Brickipedia

READ MORE

Brickipedia
Advertisement
Class 2 article


Toomanyredbricks Too many red bricks!
This article has an excess of red links in it.
Attention is requested to create new articles from these links. Please remove this message when finished.
LEGO → System → Star Wars
10187 << 10188 >> 10189 284px-LEGO logo.svg


The 10188 Death Star is a LEGO Star Wars set based on the Death Star and Death Star II from the Star Wars movies.

Description

Rooms and Features

This set contains rooms from the Death Star in Star Wars Episode IV: A New Hope and the Death Star II from Star Wars Episode VI: Return of the Jedi. Thus, this set is made to replicate a playing experience from both Death Stars. The rooms included in this set are:

  • Trash compactor.
  • Tractor beam generator room.
  • Detention block.
  • Conference chamber.
  • Superweapon firing room.
  • Room that C-3PO and R2-D2 spent much of their time on the Death Star in Episode IV.
  • Droid maintenance room.
  • Emperor's throne room.
  • Hangar bay with a mini model of Darth Vader's TIE fighter.
  • Room with crane, R2-Q5 and Death Star Protocol Droid.
  • Chasm that Luke and Leia swing across in Episode IV.
  • Room that contains two turrets.
  • Room that has a missile launcher and various guns located under the superweapon itself.

The set is 41 cm high and 42 cm wide, being nearly as round as a ball.

The set is built around a circular base made up of a triple layer of angular plates. The lowest level is directly on top of this. It has some barrels, a bunch of smaller cans, and a pipe. There are two wall pieces with a special sticker on top of which go another set of the same parts. This area spans two levels. The walls around the center each have a pair of lights/buttons on each side.

The second bag is opened on the second level after all of the floor for it has been built. There is an elevator area with red lights, a rack of laser guns, and an shaft. In the landing area there is a pair of gray and blue barrels, most likely containing fuel. The exit of the landing area has a yellow and black part "caution symbol" part. On the wall which separates the elevator area from the rest of the floor is a pulley. A string is connected to it and pulls a pair of elevators so that when one goes up the other goes down.This section has walls between rooms, unlike the section below it. Again, the shaft has buttons/lights by it. Instead of the floor spanning the entire circle, it only spans three-fourths, with one fourth being simply a long angled connection, making the room taller. It has multiple entrance/exit spots, each with lights on either side. On one of them is a large cone with transparent green parts at the top which prevents the door of the trash compactor from sliding out of the set. There are many handle "grip" parts but only one ladder. The entrance/exit to the trash compactor is the shaft. The sides can both close and it spans one sixth of the circular area. The other side of the elevator is round. On the top of the shaft on that level is a set of red lights. The wall cutting the trash compactor from the shaft is placed on a flat surface so that it can slide out. To open or close the doors of the trash compactor, there is a TECHNIC axle which can be pushed to close them or pulled to open them. There are pieces of trash that are placed in this section as well. A large laser can be found next to the trash compactor. It is composed of two lasers and a TECHNIC cannon, and can rotate and angle up and down. It is piloted by one Minifigure, but has another seat. There is a yellow claw which is piloted by one Minifigure.

The next floor has a black area over the elevator area. This area is also a landing pad and here is where a smaller TIE Fighter lands. There are three boxes and some arrows pointing towards another room. There is a hole for the elevator. The doorway to the room has an access panel like the one from the Star Wars video games. The door slides out. The area right next to it has a set of barrels and a tube. There is a ladder leading up to a control area with some computer screens and a gear which turns something. It has a window to view the room. This room also contains the hyperlaser, which can rotate and angle and has a control panel array. The room is connected to the next room by a doorway with lights on either side. There is also a hole which drops to the trash compactor and some small steps. A control panel operates a device here. The last fourth of this level has a part which stops Minifigures from falling over the edge of the area. There are some barrels and a set of openings into the tall room which are covered by some "robot arm" parts. The room has a stairway leading up to a viewing area. The viewing area has a chair which can rotate and a pair of transparent blue lights. The room's only doorway is covered by a large panel with a sticker which represents a long hallway. That doorway in turn is in its own small section. Leading to the "hallway piece" is a angled part representing the hallway as well. The area has a gear which turns to open the a hole to the trash compactor room covered by a vent. There are two control panels in the area controlling this and the gateway. There is a wall on the other side which can be raised by the turn of another gear. A control panel is right next to the gear. The area is a jail, with jail bars. A laser/camera looks into this area.

On the top floor are sleeping quarters for Imperial Stormtroopers. It contains a bed, a chair, a table, and a rack of equipment. Next to it is a room with two sets of chairs. One of them rotates the superlaser when turned. On its other side is a pair of large double-lasers. It connects to the sleep room with a small doorway too small for a Minifigure. There is also a conference room on this floor, with 7 rotating chairs and a large table. The central shaft contains an elevator which connects the conference room and the sleeping quarters to the bottom floor.

Minifigures

This set is known to be one of the more rare types of sets with many minifigures. Included in this set are 24 minifigures, 6 which are exclusive to this set. The minifigures included in this set are:

The Death Star contains a Dianoga with four "tentacles" plus a head and tail. It is mostly brown. There is also a droid which carries weapons around and is very similar to a luggage carrier from Airport sets.

Marketing

This set was sold for $399.99 in the United States of America, $499.99 in Canada, €419.99 in Europe and $699.99 in Australia. This set is No. 10188 (part of the 10000 series) and has been released for age 14 and up. It was released 2008 as part of the Star Wars theme under the A New Hope and Ultimate Collector's Series subthemes.

Background

The Death Star was a giant space station with the power to destroy entire planets. Both Death Stars were destroyed by the Rebel Alliance.

It was built in orbit of Despayre, a prison planet. The planet also held an Imperial garrison. After about 19 years, the Death Star was complete. It fired and blew up Despayre, killing prisoners as well as the Imperial garrison. At some point in the Death Star's construction, it was visited by Galen Marek.

Notes

Minifigures Included

Luke Skywalker Stormtrooper
10212 Luke Skywalker
Han Solo light flesh brown legs
Han Solo Stormtrooper
Princess Leia 10198
Ben Kenobi hood
2009 Darth Vader
Chewbacca Reddish Brown
R2 (10188)
C3pods
Emporer Palpatine (new face)
Grand Moff Tarkin
IG88
R2-Q5
Stormy
Stormy
Mouse Droid
IT-O
Death Star Droid
Death Star Trooper
Death Star Trooper
Luke Skywalker (Tatooine)Luke Skywalker (Stormtrooper disguise)Luke Skywalker
(Jedi Master)
Han Solo
(Brown legs)
Han Solo (Stormtrooper disguise)Princess LeiaBen Kenobi (hood)Darth Vader
(new design)
ChewbaccaR2-D2
(new design)
C-3PO
(new design)
Emperor Palpatine (new design)Grand Moff TarkinIG-88R2-Q5StormtrooperStormtrooperRoyal Guard
(black hands)
Royal Guard
(black hands)
Mouse DroidIT-ODeath Star DroidDeath Star TrooperDeath Star Trooper

LEGO.com Description

LEGO.com-icon-yellow This is a description taken from LEGO.com. Please do not modify it. (visit this item's product page)

Battle inside the Death Star™!

Recreate the action and adventure of the Star Wars™ movies with the ultimate Death Star playset! This amazingly detailed battle station features an incredible array of minifigure-scale scenes, moving parts, characters and accessories from Episodes IV and VI on its multiple decks, including the Death Star control room, rotating turbolaser turrets, hangar bay with TIE Advanced starfighter, tractor beam controls, Emperor’s throne room, detention block, firing laser cannon, Imperial conference chamber, droid maintenance facility, and the powerful Death Star superlaser…plus much more! Swing across the chasm with Luke and Leia, face danger in the crushing trash compactor, and duel with Darth Vader for the fate of the galaxy!

  • Includes 24 minifigures and droids, plus all-new Dianoga™ trash compactor monster!
  • Includes 6 new and exclusive minifigures and droids only found in this set: Luke Skywalker™ (Stormtrooper™ outfit), Han Solo™ (Stormtrooper outfit), Assassin Droid™, Interrogation Droid, Death Star Droid and 2 Death Star Troopers™!
  • Also includes Luke Skywalker, Han Solo, Obi-Wan Kenobi™, C-3PO™, R2-D2™, Princess Leia™, Chewbacca™, Luke Skywalker (Jedi Knight), Darth Vader™, Grand Moff Tarkin™, Emperor Palpatine™, 2 Stormtroopers, 2 Emperor's Royal Guards™, R2-Q5™, and mouse droid!.
  • Movie-authentic Death Star environments include the Superlaser control room and target monitor, Imperial conference chamber, TIE Advanced hangar bay with moving launch rack, Emperor's throne room, droid maintenance room, detention block, trash compactor, and much more!
  • Rescue Princess Leia from the detention block cell, then escape through the secret hatch to the trash compactor below!
  • Reenact the final duel between Luke Skywalker and Darth Vader in the Emperor's Throne Room!
  • Death Star measures 16” (41cm) tall and 16½” (42cm) wide!
  • TIE Advanced measures 3½" (9cm) wide!


See also

Documents

External links


Advertisement